TAHKI·STACY CHARLES Cover Pattern
Front & Back revised chart PDF [PDF 205KB]
Pattern #2, Flower Scarf
photo on pg 121, instructions begin on pg 170
Swarovski crystals used are size 8mm, not 15 mm.
Yarn amounts are incorrect.
2 hanks of #09m pewter are needed.
1 hank of all other colors is adequate.
Pattern #3, Lacy Butterfly Scarff
Photo on pg 122, instructions begin on pg 170
Updated: 21Jul2009
A corrected chart has been posted. [PDF 27KB]
Pattern #8, Cropped Cardigan
Photo on pg 127, instructions on pg 173
The garment description on page 127 is incorrect. The garment is NOT knitted in one piece to the armholes. It is knit according to the schematic on page 174
Pattern #10, Cabled Cardigan
photo on pg 128, instructions on pg 175
The chart is incorrect.
The cables shown on row 14 should be worked on row 13.
Pattern #12, Banded Tunic
photo on page 129, instructions begin on page 178
Please replace the following Inc rnd:
TOP
Joining
Inc rnd *Work in rib to next marker, yo, sl marker, k2, sl marker, yo, k to next marker, yo, sl marker, k2, sl marker, yo; rep from * once more, work to end in rib. Work next rnd even incorporating yo’s into pat sts and keeping k2 sts between markers. Rep last 2 rnds…..
Pattern #13, Side to Side Cable Top
photo on page 130, instructions on page 179
Correction is underlined.
RIGHT SLEEVE
The last Cable Rep Chart row to be worked is incorrect.
For Small, Medium and Large work the final rep of the Cable Rep Chart to row 14.
Pattern #14, Wide Brimmed Hat
photo on pg 131, instructions begin on pg 181
Directions for garter stitch are incorrect.
1. BRIM
CO 96 sts. Place marker and join for knitting in the round, taking care not to twist sts. [p1 rnd, k1 rnd] twice, p1 rnd.
Stitch number under FINISHING is incorrect substitute underlined number.
2. FINISHING
Next rnd Work 36 stitches
Pattern #17, Diagonal Cables Turtleneck
photo on pg 133, instructions begin on pg 183
Updated 01Oct2008
Correction is underlined.
CIRCULAR DIAGONAL CABLE (Left Slant)
(multiple of 9 sts)
Rnds 1-4 *K6, p3; rep from * around.
Rnd 5 *Work 6-st LC, p3; rep from * around.
Rnds 6-10 *P3, k6, rep from * around.
Rnd 11 *P3, 6-st LC; rep from * around.
Note At this point, move the beg of the rnd marker back 3 sts so that is positioned at the center of the 6-st LC of the previous rnd. The marker will rem in this place for the next 6 rnds (through rnd 17).
Rnds 12–16 *K6, p3; rep from * around.
Rnd 17 *Work 6-st LC, p3; rep from * around. Note Reposition the end of rnd marker forward 3 sts so that it is at center of the 6-st LC and back into the original spot.
Rnd 18 *K6, p3; rep from * to end.
Rep rnds 1–18 for circular diagonal cable (left slant).
Pattern #23, Gauntlet Gloves and Toque
photo on pg 139, instructions on pg 192
Corrections are underlined.
Horizontal Cable panel
Row 1 (RS) *Work row 1 of chart 1 over 4 sts, pm, p4, pm, work row 1 of chart 2 over 4 sts, pm, p4, pm; rep from *, end work row 1 of chart 2 over 4 sts, k1. Cont in pats until piece measures 2.5″ from beg. Dec 1 st in each of the p4 sections on next row – 41 sts.
Pattern #27, Map of The World Sweater
photo on page 140, instructions on page 192
Updated: 29Sep2008
A corrected chart for the right sleeve has been posted. Click here to download [PDF 41KB]
Pattern #28, Center Motif Pullover
photo on page 144, instructions on page 199
Correction is underlined.
BACK
The last row of the chart is incorrectly identified in the text. The chart ends with row 56, not row 96.
Pattern #29, Cabled Gloves
Updated: 27Feb2017
photo on page 146, instructions on page 200
Correction is underlined.
Cuff Strip
Row 5 Sl 2 sts to cn and hold to back, k2, k2 from cn, k2.
In the Stitch Key, the labels for RPT and LPT are reversed.
Pattern #30, Cabled Coat
Updated: 27Feb2017
photo on page 146, instructions on page 200
Chart 1 on page 202, row 9 is incomplete.
Please insert an RT in between the 4-st LC and the 4-st RC on the left side of the chart.
Pattern #32, Shaped Cabled Scarf
photo on page 148, instructions beg on page 204
Instructions for rows 3-25 are incomplete.
Row 3 P1, k2, p8, [k1, p1, k1, p8] 3 times,k2, p1
Row 4 K1, p2, [k8, p1, k1, p1] 3 times, k8, p2, k1
Rows 5-8 Rep rows 3 & 4 twice more
Rows 9-24 Rep rows 1-8 twice more
Row 25 As 1st row
Pattern #37, Lace Wrap Cardigan
Photo on page 152, instructions beg on page 209
Updated: 04Nov2015
Part 2 of collar should read:
Work as for Part 1 through twisted rib, then work an additional 14 rows for a total of 18 rows or 2/5cm.
Pattern #38, Lace Wrap Cardigan
Photo on pg 153, instructions on pg 211
1. The number of sts to cast on for each of the fronts/half back should be 83 sts.
2. There are corrections to both charts as follows:
Body chart – st 54, row 11 should be Ktbl.
Sleeve chart – st 55, row 11 should be Ktbl.
3. Point A is not listed on schematic, but should be located at the pointed end of the sleeve opening directly above the arrow at the bottom of the schematic.
Pattern #40, Lace Hoodie
Photo on pg 153, instructions on pg 211
1. The number of sts to cast on for each of the fronts/half back should be 83 sts.
2. There are corrections to both charts as follows:
Body chart – st 54, row 11 should be Ktbl.
Sleeve chart – st 55, row 11 should be Ktbl.
3. Point A is not listed on schematic, but should be located at the pointed end of the sleeve opening directly above the arrow at the bottom of the schematic.
Pattern #41, Lace Dress
Yarn description on page 156 should say “Greenwich Village,” not “Park Avenue.”
4-Pleat Version
photo on page 156, instructions on page 215
Updated: 03Oct2008
BODY
With circular needle, cast on 146 (154, 166, 174, 186, 194) sts. Join, being careful not to twist sts and pm to mark beg of rnd.
Rnd 1 (RS) *Work lace pat foll row 1 of chart 1, beg is indicated on chart for chosen size, working the first 15 (17, 15, 17,15, 17) sts then 11 sts of dart dec, then work 10-st rep 2 (2, 3, 3, 4, 4) times, then 11 sts of dart dec once more, then work 16 (18, 16, 18, 16, 18) sts, pm (end of back); rep from * once more for front. Cont to foll chart working the dart dec as indicated on rnds 18, 36, 54, 72 and 90. There are 106 (114, 126, 134, 146, 154) sts after dart decs are completed. Cont to work even in lace pat, rep rnds 1–6 as established until piece measures 30″/76cm from beg, end with rnd 5 of pat st.
Armhole shaping
Next rnd (RS) Bind off 1 (3, 5, 3, 5, 3) sts, k until there are 50 (50, 52, 60, 62, 70) sts on needle, bind off next 3 (7, 11, 7, 11, 7) sts, k until there are 50 (50, 52, 60, 62, 70) sts on needle, bind off rem 2 (4, 6, 4, 6, 4) sts. Cut yarn.
Back armhole shaping
Next row From the RS, rejoin yarn at beg of back and with straight needles, cont to shape armhole by dec’ing 1 st each side of this row and every other row 1 (1, 2, 1, 2, 1) times more—46 (46, 46, 56, 56, 66) sts. Work even in lace pat until armhole measures 6 (6 1/2, 7, 7 1/2, 8, 8 1/2)”/15 (16.5, 18, 19, 20.5, 21.5)cm.
Back neck shaping
Next row (RS) Work 12 (12, 12, 15, 15, 19) sts, join a 2nd ball of yarn and bind off center 22 (22, 22, 26, 26, 28) sts, work to end. Working both sides at once, dec 1 st at each neck edge every other row twice. Bind off rem 10 (10, 10, 13, 13, 17) sts each side for shoulders.
Front armhole shaping
Shape as for back armhole—46 (46, 46, 56, 56, 66) sts. Work even until armhole measures 3 (3 1/2, 4, 4 1/2, 5, 51/2)”/7.5 (9, 10, 11.5, 12.5, 14)cm. Front neck shaping
Next row (RS) Work 17 (17, 17, 20, 20, 24) sts, join a 2nd ball of yarn and bind off center 12 (12, 12, 16, 16, 18) sts, work to end. Working both sides at once, dec 1 st at each neck edge every other row 7 times—10 (10, 10, 13, 13, 17) sts. Work even, if necessary, until armhole measures same as back. Bind off sts each side for shoulders.
Pattern #43, Diagonal St Coat
photo on pg 158, instructions begin on pg 218
Updated: 27Mar2012
The belt tabs should be sewn to the ribbed “waistband”, centered under the armholes with the buttonholes toward the front edge of the sweater.
Pattern #46, Michael Kors Cape
photo on pg 161, instructions on page 221
Buttonhole row is incorrect—work to the last 6 sts, ssk, yo twice, k2tog, k2.
Pattern #48, Fur Banded Coat
photo on pg 163, instructions begin on pg 223
1. Amount given for Fur yarn is incorrect
12 (13, 13) 15g skeins
2. Sleeve instructions are incorrect
Inc each side every 8th row 11 times—69 sts.
3. Yoke instructions are incorrect
When all pieces are assembled on needle for yoke—188 (196, 208)sts.
Next row (RS) With Merino navy (D), inc 1 (0, 2) sts—189 (196, 210) sts.
Beg chart 7
Work rows 1–5 of chart 7, using D and C with k2tog in D on row 5 in each of the 27 (28, 30) pattern reps—162 (168, 180) sts.
Beg chart 8
Work rows 1–5 of chart 8, using D and L continue in half-linen st with a k2tog in L on row 5 in each pattern rep—135 (140, 150) sts.
Next 3 rows With G, work in St st.
Beg chart 9
Work rows 1 and 2 of chart 9, using G and J with a k2tog in J on row 2 in each pattern rep—108 ( 112, 120) sts.
Next row With J, work in St st.
Next row With J dec 27 ( 28, 30) sts evenly spaced – 81 ( 84, 90) sts.
Next row With J, work in St st AND dec 3 ( 6, 12) sts evenly spaced – 78 sts.
Next row With J, bind off.
